Avaya P332G-ML manual Set vlan Command, Set port flowcontrol Command

Chapter 5 CLI – Layer 2

Management VLAN number set to 1

Set vlan Command

Use the set vlan command to create vlans.

The syntax for this command is:

set vlan <vlan-id> [name <vlan-name>]

vlan-id	vlan number
vlan-name	vlan name

Example:

P330-N# set vlan 3 name v3

VLAN ID 3 is named v3.

Note: If you wish to define a name which includes spaces, you must enclose the entire name in quotation marks, e.g. "new york".

Set port flowcontrol Command

Use the set port flowcontrol command to set the send/receive mode for flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each direction (send or receive) can be configured separately only for Gigabit Ethernet ports. Proprietary flow control cannot be configured on Gigabit ports. The set flowcontrol command cannot be used on Gigabit ports for which autonegotiation is enabled.

The syntax for this command is:

set flowcontrol [direction] [module/port] [value]

direction	•	receive/send/all
module/port	•	module/port number
value	•	on/off/proprietary

Example:

P330-1(super)# set port flowcontrol all 2/20 on

Port 2/20 flow control administration status set to on

P332G-ML User’s Guide 105