
Chapter 5 | CLI – Layer 2 |
|
|
Note: This command is not supported for
Set port duplex Command
Use the set port duplex command to configure the duplex mode of a
Note:
The syntax for this command is:
set port duplex <mod_num>/<port_num> {fullhalf}
Example:
To set port 1 on module 2 to full duplex:
Port 2/1 set to
Set port name Command
Use the set port name to configure a name for a port. If you do not specify a name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
name | Name assigned to the port. |
Example:
P330-N# set port name 1/2 arthur
Port 1/2 name set.
95 |