Chapter 5

CLI – Layer 2

 

 

Resetting module 4...

Nvram initialize Command

Use the nvram initialize command to reset the P330 parameters to the factory defaults. If no options are specified for this command, only the Layer 2 parameters will be reset.

The syntax for this command is:

nvram initialize [switchall]

switch

Resets all the switching level parameters (Layer 2 only) throughout

 

the stack

all

Resets all parameters including licenses and routing parameters of

 

the Layer 3 modules present in the stack

Example:

P330-N# nvram initialize

This command will force a factory default and switch-over to the master module and disconnect your telnet session.

Do you want to continue (y/n) [n]? y

Connection closed by foreign host.

host%

Configure Command

The configure command is not used in the Layer 2 CLI. It is used with the Layer 3 CLI. Use the configure command to enter Configure Mode (See Security Levels on page 220).

Rmon history Command

Use the rmon history command to create an RMON history entry.

The syntax for this command is:

rmon history <history index> [<module>[</port>]] interval <interval> buckets <number of buckets> owner <owner name>

history_index

This is the history index number of this entry (it is advisable to

 

use the same interface number as your history index number)

module/port

The module number/the port numbe.r

P332G-ML User’s Guide

115

Page 133
Image 133
Avaya P332G-ML manual Resetting module, Nvram initialize Command, Nvram initialize switchall, Configure Command