
Chapter 4 Installation and Setup
Assigning P332G-ML Initial Router Parameters
This section is only applicable if you either purchased a Layer 3 preconfigured
To configure the initial router parameters perform the following via the CLI:
1Enter set
2Type y.
Wait for the module to restart and for the CLI prompt to reappear.
3Type show
Note: Assign the stack IP address as described in Assigning P330’s IP Stack Address on page 37 before you assign the Initial Router IP address.
4To access Router commands from the Master module, type the command session <module number> router where <module number> is the location of the
The command prompt changes from Console> to
5Type configure and press Enter. The prompt
Note: If the IP interface is not on VLAN #1, continue with step 6, otherwise skip to step 8.
6Create the management/routing VLAN. Use the command
set vlan
7Create an IP interface name. Type:
Router(configure)# interface <interface-name>
Press Enter.
The Router(configure-if:<interface-name>)# prompt appears.
8Assign the IP address and network mask of the IP interface you have created. Use the command:
Press Enter
9Type exit and press Enter. This returns you to the prompt:
38 |