(32) Remove the two Flat cables from the Main PCB.
Note :
•After disconnecting flat cable(s), check that each cable is not damaged at its end or
(33)Remove the six cup S M3x6 Taptite screws.
(34)Remove the Protective film from the Flat cable.
(35)Pull out the two Flat cables from the Core.
(36)Remove the Laser unit.
Note :
•Be careful not to lose the Protective film attached on the flat cable.
•Do not touch the Laser scanner window directly.
Core
Laser unit
LD harness (Flat cable)
Main PCB
Polygon motor | Main PCB | |
(Flat cable) | ||
|
Protective film
Laser unit
LD harness (Flat cable)
Taptite cup S M3x6
Core
Protective film
Taptite cup S M3x6
Polygon motor (Flat cable)
Fig.
Confidential |