<Function>
This function allows you to adjust the scanning start and end positions with the ADF and FB unit.
<Operating Procedure>
(1)Press the [5] and [4] keys in this order in the initial stage of the maintenance mode. The “SCAN START ADJ.” will appear on the LCD.
(2)The “
: ADF 
: FB” will appear after two seconds.
Select one of them that you want to adjust the start position.
If you want to adjust the start position of the ADF, press [
] button, and if you want to adjust that of the FB unit, press [
] button.
(3)Press the [1] or [2] key to display the present compensation level for the start position. Compensation levels can be adjusted in 11 steps from +5 to
(4)Press the [
] button to increase compensation levels, and the [
] button to lower them. Press the [Stop/Exit] button so that the machine beeps for one second and returns to the initial state of the maintenance mode without adjusting compensation levels.
(5)Set the compensation level and press the [OK] button.
The “ACCEPTED” will appear on the LCD. One second later, the machine “
: ADF 
: FB” will appear on the LCD.
(6)Press the [Stop/Exit] button when finish the adjustment. The machine beeps for one second and returns to the initial state of the maintenance mode.
Note:
•The correlation between the scan start/end positions and compensation levels is shown below.
Fig.
Confidential |