(2) Lift up the CCD Module and Guide shaft and pull the Guide shaft out of the CCD Module.

CCD Module

Guide shaft

2b

2a

Scanner base

Fig. 5-101

(3)Remove the Belt support rubber, and then remove the Belt from the CCD module.

(4)Remove the double-faced adhesive tape which is attached between the FFC cable and CCD module, and disconnect the FFC cable from the CCD module.

Note:

•After disconnecting flat cable(s), check that each cable is not damaged at its end or short-circuited.

•When connecting flat cable(s), do not insert them at an angle. After insertion, check that the cables are not at an angle.

Belt support rubber

Belt

CCD module

3a

3b

Belt

FFC cable

 

Fig. 5-102

5-85

Confidential