■Error code 84
Jam Rear
Open the Back Cover and remove the jammed paper, then press Start.
Paper jam
User Check
• Check if the paper is jammed around the opened back cover. If jammed, remove it.
Step | Cause | Remedy | |
|
|
| |
|
|
| |
1 | Harness connection failure of relay | Check the harness connection of the relay | |
rear PCB ASSY. | rear PCB ASSY and reconnect it. | ||
| |||
|
|
| |
2 | Eject actuator catching on some | Correct catching of the eject actuator. | |
position |
| ||
|
| ||
|
|
| |
| Paper eject sensor PCB failure | Check the sensor performance following | |
3 |
| the procedure described in “Maintenance | |
| mode 32”. If any problem occurs, replace | ||
|
| ||
|
| the relay rear PCB ASSY. | |
|
|
| |
4 | Main PCB failure | Replace the main PCB ASSY. | |
|
|
|
■Error code 85
No Tray
A Tray is not detected, install Tray 1.
Tray 1 is not installed into the machine
Error code 86
No Tray
A Tray is not detected, install Tray 2.
Tray 2 is not installed into the machine
User Check
•Check if the applicable tray is installed into the machine.
•Check if the paper is jammed in the applicable tray.
Step |
| Cause | Remedy |
|
|
|
|
|
|
|
|
| T1 | PE/edge sensor PCB/ | Check the sensor performance following |
| T2 | PE/edge sensor PCB failure | the procedure described in “Maintenance |
1 |
|
| |
|
|
| the T1 PE/edge sensor PCB failure/T2 PE/ |
|
|
| edge sensor PCB. |
|
|
| |
| Harness connection failure of | Check the harness connection of the T1 | |
2 | T1 | PE/edge sensor PCB/ | PE/edge sensor PCB/T2 PE/edge sensor |
| T2 | PE/edge sensor PCB. | PCB. and reconnect it. |
|
|
| |
3 | Main PCB failure | Replace the main PCB ASSY. | |
|
|
| |
4 | Connector | Replace the connector | |
(only Tray 2) |
| ||
|
| ||
|
|
|
|
Confidential |