■Error code 8D
Cover is Open
Make sure there is no paper jammed inside the machine and close the Back Cover, then press Start.
Paper jam near eject tray
User Check
• Check if the paper is jammed in the back cover. If jammed, remove it.
Step | Cause | Remedy |
|
|
|
|
|
|
| DX sensor failure | Check the sensor performance following |
1 |
| the procedure described in “Maintenance |
| mode 32”. If any problem occurs, replace | |
|
| |
|
| the relay rear PCB ASSY. |
|
|
|
2 | Main PCB failure | Replace the main PCB ASSY. |
|
|
|
■Error code 99
Size mismatch DX
Press Job Cancel. Specify the correct paper and load the same size paper as the Printer driver setting.
Specified paper size is not supported for duplex printing (DX)
User Check
•Remove the jammed paper, and use the A4 size or letter size paper, and load the same size paper as the printer driver setting.
Step | Cause | Remedy |
|
|
|
|
|
|
1 | Main PCB failure | Replace the main PCB ASSY. |
|
|
|
Confidential |