(1)Remove the Hooks of the Air duct from the frame. Slide the Air duct to the direction of 1b and remove the Air duct.
PinLaser unit
1a | Hook |
|
1b
Hook |
|
Air duct | Hook |
| Hook |
| Fig. |
(2)Remove the five cup S M3x6 Taptite screws.
(The left back screw has already remove at “8.13 Main Shield Plate ASSY“)
(3)Remove the Protective film from the Flat cable.
(4)Pull out the two Flat cables from the Core.
(5)Remove the Laser unit.
Note:
•Be careful not to lose the Protective film attached on the flat cable.
•Do not touch the Laser scanner window directly.
Polygon motor (Flat cable)
Laser unit
Taptite, cup S M3x6
Core
Protective film
Taptite, cup S M3x6
LD harness (Flat cable)
Fig.
Assembling Note:
• Before assembling the Laser unit, make sure put on the Core.
Confidential |