Cisco Systems 2.5 How Do I Create a VPN to More Than One Site?

11-31
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Chapter11 Site-to-Site VPN
How Do I...
Rule Type
The type of NAT rule, either Static or Dynamic.
To make the listed NAT rules use route maps:
Click OK.
How Do I...
This section contains procedures for tasks that the wizard does not help you
complete.
How Do I Create a VPN to More Than One Site?
You can use Cisco SDM to create multiple VPN tunnels on one interface on your
router. Each VPN tunnel will connect the selected interface on your router to a
different subnet at the destination router. You can configure multiple VPN tunnels
to connect to the same interface but to different subnets on the destination router,
or you can configure multiple VPN tunnels that will connect to different interfaces
on the destination router.
First, you must create the initial VPN tunnel. The steps below describe how to
create the initial VPN tunnel. If you have already created your first VPN tunnel
and need to add an additional tunnel to the same interface, skip the first procedure
and perform the steps in the next procedure in this help topic.
Create the initial VPN tunnel:
Step1 From the left frame, select VPN.
Step2 Select Create a Site-to-Site VPN .
Step3 Click Launch the Selected Task.
The VPN Wizard starts.
Step4 Click Quick Setup.
Step5 Click Next>.