Cisco Systems 2.5 How Do I Edit a Radio Interface Configuration?

2-11
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Chapter2 Creating a New Connection
Additional Procedures
Step7 If you want to configure the router to end the connection when the connection is
idle, i.e., no traffic passes across it, for a specified amount of time, in the Idle
timeout field, enter the number of seconds the connectio n can remain idle before
the router ends the connection.
Step8 If you are editing an ISDN connection, and you would like to use your second B
channel only when the traffic on the first B channel exceeds a certain threshold,
check the Enable MultiLink PPP check box, then in the Load Threshold field,
enter a number between 1 and 255, where 255 equals 100% of bandwidth, that will
determine the threshold on the first B channel. When traffic on that channel
exceeds that threshold, it will cause the router to connect the second B channel.
In addition, in the Data direction field, you can choose whether this threshold
should apply to outbound or inbound traffic.
Step9 Click OK.
How Do I Edit a Radio Interface Configuration?
You must use the Wireless Application to edit an existing radio interface
configuration.
Step1 Click Configure on the Cisco SDM toolbar.
Step2 Click Interfaces and Connections in the left frame, and then click the Edit
Interface/Connection tab.
Step3 Choose the radio interface and click Edit. In the Connections tab, you can change
the IP address or bridging information. If you want to change othe r wireless
parameters, click Launch Wireless Application.