42-25
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Chapter42 Viewing Router Information
Traffic Status
QoS
The QoS Status window allows you to monitor the performance of the traffic on
QoS configured interfaces (see Associating a QoS Policy With an Interface). This
window also allows you to monitor bandwidth utilization and bytes-sent for
interfaces with no QoS configuration. Monitoring inbound traffic on QoS
interfaces shows the statistics only at a protocol level. Protocol-level statistics for
non-QoS interfaces are collected for traffic in both directions.
This window allows you to monitor the following sta tistics:
Bandwidth utilization for Cisco SDM defined traffic types
Bandwidth utilization per class under each traffic type
Bandwidth utilization for protocols under each class
Bandwidth utilization is shown in Kbps.
Total incoming and outgoing bytes for each traffic type
Incoming and outgoing bytes for each class defined under the traffic type
Incoming and outgoing bytes for each protocol for each class
If the value is more than 1,000,000, then the graph may show the bytes as a
multiple of 10^6. If the value is more than 1,000,000,000, then the graph may
show the bytes as a multiple of 10^9.
Packets dropped statistics for each traffic type

Interface—IP/Mask—Slot/Port—Description

This area lists the interfaces with associated QoS policies, their IP addresses and
subnet masks, slot/port information if applicable, and available descriptions.
Select the interface that you want to monitor from this list.

View Interval

Select the interval at which statistics should be gathered:
Now—Statistics are gathered when you click Start Monitoring.
Every 1 minute—Statistics are gathered when you click Start Monitoring,
and refreshed at 1-minute intervals.