Chapter15 DMVPN
Edit Dynamic Multipoint VPN (DMVPN)
15-14
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Delete
Click to delete a DMVPN tunnel configuration.
General Panel
In this panel add or edit general configuration parameters of the DMVPN tunnel .
IP Address
Enter the IP address of the tunnel. This must be a private address and must be in
the same subnet as the other tunnel addresses in the DMVPN. If you are
configuring a spoke, you must use the address that the hub administrator has
assigned to your router so that no address conflicts occur.
Mask
Enter the subnet mask that the hub administrator has assigned to the DMVPN. For
more information, see IP Addresses and Subnet Masks.
Tunnel Source
Select the interface that the tunnel is to use, or enter that interface’s IP address.
See Using Interfaces with Dialup Configurations before you select an interface
configured for a dialup connection.
Tunnel Destination
Click This is a multipoint GRE tunnel if this is a DMVPN tunnel in a
fully-meshed network. Click IP/Hostname and specify an IP address or hostname
if this is a hub-and-spoke network
IPSec Profile
Select a configured IPSec profile for this tunnel. The IPSec profile defines t he
transform sets that are used to encrypt traffic on this tunnel.