General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-75
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the Cisco Discovery Protocol timer to 120 seconds:
3.2.6.7 set ciscodp holdtime
Use this command to set the time to live (TTL) for Cisco Discovery Protocol PDUs. This is the
amount of time (in seconds) neighboring devices will hold PDU transmissions from the sending
device.
set ciscodp holdtime time
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
time Specifies the number of seconds between PDU
transmissions. Valid values are 5 - 254.
Matrix>set ciscodp timer 120
time Specifies the time to live for PDUs. Valid values are 10 -
255.