Port Configuration Command Set
Setting Speed and Duplex Mode
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-15
Example
This example shows how to display configured port speed for front panel ports 10 through 16:
4.3.3.2 set port speed
Use this command to configure the default speed of a port interface. This setting only takes effect
on ports that have auto-negotiation disabled.
You can use this command to configure the default speed of a port while auto-negotiation is
enabled. However, the configured speed will not take effect until auto-negotiation is disabled.
set port speed port-string {10 | 100 | 1000}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
E1-2>show port speed fe.0.10-16
When autonegotiation is disabled,
the port speed setting is:
port speed
--------------------
fe.0.10 10
fe.0.11 10
fe.0.12 10
fe.0.13 10
fe.0.14 10
fe.0.15 10
fe.0.16 10
port-string Specifies the port(s) for which speed will be set. For a
detailed description of possible port-string values, refer
to Section 4.1.2.
10 | 100 | 1000 Specifies the port speed. Settings can be 10 Mbps, 100
Mbps, or 1000 Mbps.