VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-37
Syntax Description
Command Defaults
Data masks are required only for classification types requiring a second
data_value. For details, refer to Table 7-2.
Command Type
Switch command.
Command Mode
Read-Write.
Command Alternative (v2.05.xx and higher)
clear policy port (Section 8.3.3.3)
Example
This example shows how to remove Fast Ethernet front panel port 21 from the Source UDP Range
classification rule to filter out (drop) incoming frames:
vlan-id Specifies the number of the VLAN to remove from the
classification rule.
port-string Specifies the port(s) to remove from the classification
rule. For a detailed description of possible port-string
values, refer to Section 4.1.2.
data_meaning Specifies the data_meaning for the parameter used to
classify or filter frames. Refer to Table 7-1 and Table 7-2
for lists of the data_meanings and associated protocol
types and classifications.
data _value Specifies the code of a predefined classifier. The range of
values is dependent on the data_meaning. Refer to
Table 7-1 and Table 7-2 for the limitations.
data_mask (Not required for most data values.) This entry is
dependent on the data_value entered. For details, refer to
Table 7-2.
Matrix>clear vlan classification ingress 6 fe.0.21 src-udp-range 45 53