Port Configuration Command Set
Setting Port Traps
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-39
4.3.7 Setting Port Traps
Purpose
To display the status, and to enable or disable an SNMP link trap on one or more ports. This
operation is typically used to alert the system manager of a change in the link status of the port.
Command
The commands needed to display, enable or disable port traps are listed below and described in the
associated section as shown.
•show port trap (Section 4.3.7.1)
•set port trap (Section 4.3.7.2)
4.3.7.1 show port trap
Use this command to display the status of an SNMP link trap on one or more ports.
show port trap [port-string]
Syntax Description
Command Defaults
If port-string is not specified, the trap status for all ports will be displayed.
Command Type
Switch command.
Command Mode
Read-Write.
port-string (Optional) Displays trap status for specific port(s). For a
detailed description of possible port-string values, refer to
Section 4.1.2.