Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
6-30 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1D:
6.2.1.32 clear spantree legacypathcost
Use this command to reset path cost to 802.1D values.
clear spantree legacypathcost
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset legacy path cost:
6.2.1.33 show spantree tctrapsuppress
Use this command to display the status of topology change trap suppression on Rapid Spanning
Tree edge ports.
show spantree tctrapsuppress
Matrix>set spantree legacypathcost enable
Matrix>clear spantree legacypathcost