Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-21
6.2.1.18 show spantree bridgehellomode
Use this command to display the status of bridge hello mode on the device. When enabled, a single
bridge administrative hello time is being used. When disabled, per-port administrative hello times
are being used.
show spantree bridgehellomode
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the Spanning Tree bridge hello mode. In this case, a single
bridge hello mode has been enabled using the set spantree bridgehellomode command as
described in Section 6.2.1.21:
6.2.1.19 set spantree bridgehellomode
Use this command to enable or disable bridge hello mode on the device.
set spantree bridgehellomode {enable | disable}
Syntax Description
Command Defaults
None.
Matrix>show spantree bridgehellomode
Bridge Hello Mode is currently enabled.
enable Enables single Spanning Tree bridge hello mode.
disable Disables single Spanning Tree bridge hello mode, allowing
for the configuration of per-port hello times.