Port Priority and Classification Configuration Commands
Configuring Priority to Transmit Queue Mapping
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 9-7
Command Type
Switch Command.
Command Mode
Read-Write.
Example
This example shows how to reset Fast Ethernet front panel port 11 to the default priority:
9.3.2 Configuring Priority to Transmit Queue Mapping
Purpose
To do the following:
•View the current priority to transmit queue mapping of each port, which includes both physical
and virtual ports.
•Configure each port to either transmit frames according to the port priority transmit queues (set
using the set port priority command described back in Section 9.3.1.2), or according to a
priority based on a percentage of port transmission capacity (set using the set priority queue
command described in Section 9.3.2.2).
Commands
The commands used in configuring transmit priority queues are listed below and described in the
associated section.
•show priority queue (Section 9.3.2.1)
•set priority queue (Section 9.3.2.2)
9.3.2.1 show priority queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit priority queue (0 -3, with 0 being the lowest priority) for each
priority of the selected port. A frame with a certain port priority is transmitted according to the
settings entered using the set priority queue command described in Section 9.3.2.2.
show priority queue [priority]
Matrix>clear port priority fe.0.11