Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Bridge Parameters
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 6-11
6.2.1.4 set spantree version
Use this command to set the version of the Spanning Tree protocol to RSTP (Rapid Spanning Tree
Protocol) or to STP 802.1D-compatible.
set spantree version {mstp | rstp | stpcompatible}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to change the Spanning Tree version from the default of MSTP to STP:
6.2.1.5 clear spantree version
Use this command to reset the version of the Spanning Tree protocol to the default mode of MSTP.
clear spantree version
Syntax Description
None.
NOTE: In most networks, Spanning Tree version should not be changed from its
default setting of mstp (Multiple Spanning Tree Protocol) mode. MSTP mode is fully
compatible and interoperable with legacy STP 802.1D and Rapid Spanning Tree
(RSTP) bridges. Setting the version to stpcompatible mode will cause the bridge to
transmit only 802.1D BPDUs, and will prevent non-edge ports from rapidly transitioning
to forwarding state.
mstp Specifies Spanning Tree version 802.1s (MSTP).
rstp Specifies Spanning Tree version 802.1w (RSTP).
stpcompatible Specifies STP 802.1D-compatible.
Matrix>set spantree version stpcompatible