SNMP Command Set
Configuring SNMP Notification Parameters
5-48 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.7.1 show trap
Use this command to display SNMP trap configuration information.
show trap
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only
Example
This example shows how to display the SNMP trap configuration. In this case, there are two SNMP
traps enabled. One is assigned to the “orange” community at IP address 1.2.3.4. Another is assigned
to the “blue” community at IP address 100.54.5.112.
Table 5-11 provides an explanation of the command output. For details on using
the set trap command to assign variables, refer to Section 5.2.7.2.
Matrix>show trap
Community Name IP Address Status
-------------------- --------------- --------
orange 1.2.3.4 enabled
blue 100.54.5.112 enabled
public 0.0.0.0 disabled
public 0.0.0.0 disabled
public 0.0.0.0 disabled
Table 5-11 show trap Output Details
Output What It Displays...
Community Name Community name of the trap.
IP Address IP address of the trap.
Status Whether the trap is enabled or disabled.