Port Priority and Classification Configuration Commands
Configuring Port Traffic Rate Limiting
9-36 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
9.3.6.2 set port ratelimit
Use this command to configure the traffic rate limiting status and threshold (in bits per second) for
one or more ports.
set port ratelimit {disable | enable port-string priority threshold {discard |
marked}{disable | enable}}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
disable | enable Disables or enables rate limiting globally on the device.
port-string Specifies port(s) on which to set the rate limiting
threshold and other parameters. For a detailed
description of possible port-string values, refer to
Section 4.1.2.
priority Specifies the 802.1D port priority level associated with
the port-string. Valid values are:
•0 - 7, with 0 specifying the lowest priority, and
•all to set the rate limiting threshold and other
parameters on all port priority levels associated with
the port-string.
threshold Specifies a port rate limiting threshold in bits per second.
Range is 195000 up to the maximum bits per second rate
for a given interface.
discard | marked Discards all frames, or discards marked frames when set
rate limit is reached.
disable | enable Disables or enables the port rate limiting function on
selected ports when the global device rate limiting
function is enabled.