Process Overview: Routing Protocol Configuration
Configuring RIP
13-20 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.1.17ip rip disable-triggered-updatesUse this command to prevent RIP from sending triggered updates. Triggered updates are sent when
there is a change in the network and a new route with a lower metric is learned, or an old route is
lost. This command stops or starts the interface from sending these triggered updates. By default
triggered updates are enabled on a RIP interface.
ip rip disable-triggered-updates
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command allows RIP to respond to a request for a triggered
update:
no ip rip disable-triggered-updates
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
This example shows how to prevent RIP from responding to a request for triggered updates on
VLAN 1:
13.1.1.18ip split-horizonUse this command to enable or disable split horizon mode for RIP packets. Split horizon prevents
packets from exiting through the same interface on which they were received.
ip split-horizon [poison]
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip disable-triggered-updates