Port Configuration Command Set
Configuring Static Port Trunking
4-52 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
This example shows how to display trunking information when the device is in port trunking mode:
This example shows how to display trunking information for trunk2 when the device is in port
trunking mode:
Table 4-7 provides an explanation of the command output.
Matrix>show trunk
Device is in portTrunking mode.
Trunking algorithm is round robin.
trunkName: newtrunk1 Admin Status: enabled Oper Status: up
trunkName: trunk2 Admin Status: disabled Oper Status: down
Matrix>show trunk trunk2
trunk port: fe.0.10
trunk port fe.0.11
trunk port fe.0.12
Table 4-7 show trunk Output Details
Output What It Displays...
Device is in... Trunking mode of the device. Default of 802.3ad can be
changed using the set trunkmode command
(Section 4.3.11.2).
Trunking
algorithm is... Whether the trunking algorithm is round robin (default) or
MAC hashing. Default can be changed using the set trunk
algorithm command (Section 4.3.11.7).
trunkName Name and status of trunk(s) configured in port trunking
mode.
LACP Rx/Tx (Displayed in 802.3ad mode only.) Whether LACP is
enabled or disabled. Default (enabled) can be changed using
the set lacp command (Section 4.3.13.1).
System Identifier (Displayed in 802.3ad mode only.) Device MAC address.
Agg (Displayed in 802.3ad mode only.) Link Aggregation Group
designations. Statically formed LAGs are indicated with an
“S” preceding the aggregator name.