IP Configuration Command Set
Configuring Broadcast Settings
12-22 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
12.2.4 Configuring Broadcast Settings
Purpose
To configure IP broadcast settings.
Commands
The commands needed to configure IP broadcast settings are listed below and described in the
associated section as shown:
•ip directed-broadcast (Section 12.2.4.1)
•ip helper-address (Section 12.2.4.3)
•ip forward-protocol (Section 12.2.4.2)
12.2.4.1 ip directed-broadcast
Use this command to enable or disable IP directed broadcasts on an interface.
ip directed-broadcast
Syntax Description
None.
Command Syntax of the “no” Form
The “no” form of this command disables IP directed broadcast globally:
no ip directed-broadcast
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.