IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-28 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Example
This example shows how to display IP protocol information. In this case, the routing protocol is RIP
(Routing Information Protocol). For more information on configuring RIP parameters, refer to
Section 13.1.1:
12.2.5.2 show limits
Use this command to display memory usage information about IP protocols running on the device.
show limits
Syntax Description
None.
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router(config)#
Command Defaults
None.
Matrix>Router#show ip protocols
Routing Protocol is "rip"
Sending updates every 30 seconds
Next due in 19 seconds
Invalid after 180 seconds, hold down 120, flushed after 300
Incoming update filter list for all interfaces is not set
Outgoing update filter list for all interfaces is not set
Default Version Control:
Interface Send Recv Key-chain
Vlan 1 1 1
Vlan 2 1 1
Routing for Networks:
182.127.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 1)