General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 3-77
Syntax Description
Command Defaults
If port-string is not specified, Cisco DP information will be displayed for all ports.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display Cisco Discovery Protocol information for all Gigabit Ethernet
ports:
Table 3-8 provides an explanation of the command output.
port-string (Optional) Displays information about specific port(s). For
a detailed description of possible port-string values, refer to
Section 4.1.2.
Matrix>show port ciscodp info ge.*.*
Port State VVID #Neigh PDU-TX PDU-RX CosExt TrustExt
-----------------------------------------------------------------
ge.0.1 Disabled none 0 0 0 undef undef
ge.0.2 Disabled none 0 0 0 undef undef
ge.0.3 Disabled none 0 0 0 undef undef
ge.0.4 Disabled none 0 0 0 undef undef
ge.0.5 Disabled none 0 0 0 undef undef
ge.0.6 Disabled none 0 0 0 undef undef
Table 3-8 show port ciscodp info Output Details
Output What It Displays...
Port Port designation.
State Whether Cisco DP is enabled or disabled on this port.
Default state of disabled can be changed using the set port
ciscodp status command (Section 3.2.6.11).