SNMP Command Set
Configuring SNMP Users, Groups and Communities
5-16 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
5.2.2.2 set snmp user
Use this command to create a new SNMPv3 user.
set snmp user user [authentication md5 [privacy]] [remote remoteid] [volatile |
nonvolatile]
Syntax Description
Command Defaults
•If authentication is not specified, no authentication will be applied.
•If privacy is not specified, no encryption will be applied.
Table 5-4 show snmp user Output Details
Output What It Displays...
EngineId SNMP local engine identifier.
Username SNMPv1 or v2 community name or SNMPv 3 user
name.
Auth protocol Type of authentication protocol applied to this
user.
Privacy protocol Whether a privacy protocol is applied when
authentication protocol is in use.
Storage Type Whether access entries for this group are stored in
volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or
notReady.
user Specifies a name for the SNMPv3 user.
authentication md5 (Optional) Specifies the authentication type required for
this user as MD5.
privacy (Optional) Applies DES encryption.
remote remoteid (Optional) Registers the user on a specific remote SNMP
engine.
volatile |
nonvolatile (Optional) Specifies a storage type for this user entry.