Port Configuration Command Set
Configuring Link Aggregation
4-68 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
4.3.13.5 set port lacp
Use this command to set link aggregation parameters for one or more ports. These settings will
determine the specified underlying physical ports’ ability to join a LAG, and their administrative
state once aggregated.
set port lacp {[aadminstate port-string state] [padminkey port-string{value |
default}] [enable | disable] port-string}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
aadminstate
port-string state Sets one or more port’s active/passive, timeout, and
aggregable status. Valid entries and their corresponding
actions are:
•active - Enables active LACP operation.
•aggregable - Enables aggregations on this port.
•default - Enables default values (active, long-timeout,
aggregable).
• inaggregable - Disables aggregations on this port.
• long-timeout - Enables a long LACP time out (30
seconds).
• passive - Enables passive LACP operation.
• short-timeout - Enables a short LACP timeout (3
seconds).
padminkey
port-string value |
default
Sets one or more port’s partner admin key. In the absence
of LACPDU’s, LACP will use this value as the partner
operational key value in the port’s LAG ID. Ports with
the same LAG ID will attempt to aggregate if other
system conditions favor aggregation. Valid values are 1 -
65535 or default, which clears matching admin keys.
enable | disable
port-string Enables or disables LACPDU processing on one or more
ports.