VLAN Configuration Command Set
Assigning VLANs According to Classification Rules
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 7-25
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Command Alternative (v2.05.xx and higher)
show policy class (Section 8.3.2.1)
Example
This example shows that the VLAN classification function is enabled, and that two VLAN
classifications have been configured on the device:
7.3.5.2 set vlan classification
Use this command to
•assign or contain frames according to classification rule,
•enable or disable the global classifier on the device,
•create a rule that will assign untagged traffic to a VLAN based on Layer 2/3/4 classification
rules, and
•enable or disable a classification rule associated with a VLAN.
Matrix>show vlan classification
VLAN Classification enabled.
Vlan Classification Entries
--------------------------------
Vlan ID: 5, Src UDP Range: 45-53, Status: enabled,
Action Status: Forward No Frames
Port List: None
----------
Vlan ID: 7, Ethernet II Type: IP, Status: enabled,
Action Status: Forward All Frames
Port List: None