Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-84 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to re-initialize CEP ports fe.1.3-5:
11.2.6.11clear cep
Use this command to clear convergence end points parameters.
clear cep {[all | policy | detection] [port port-string {all | cisco | h323 |
siemens}]}
Syntax Description
Command Defaults
None.
port-string Specifies the CEP-enabled port(s) to re-initialize. This must
be a port-string enabled for CEP using the set cep port
command as described in Section 11.2.6.3. For a detailed
description of possible port-string values, refer to
Section 4.1.2.
Matrix>set cep initialize fe.1.3-5
all | policy |
detection Clears all CEP parameters, or specifies that policy or
detection parameters will be cleared.
port port-string
cisco | h323 |
siemens
Resets the CEP default enable state to disabled on specific
port(s) for Cisco, H.323 or Siemens phone detection. For a
detailed description of possible port-string values, refer to
Section 4.1.2.