Logging and Network Management Command Set
Managing Switch Network Addresses
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 11-33
11.2.2.10disconnect
Use this command to close an active console port or Telnet session when operating in switch mode.
disconnect {ip_address | console}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to close a Telnet session to host 10.1.10.10:
This example shows how to close the current console session:
11.2.3 Managing Switch Network Addresses
Purpose
To display, add or delete switch ARP table entries, to display or set the status of RAD (Runtime
Address Discovery) protocol, to display or delete MAC address information, to configure MAC
address aging time, to configure DNS, and to execute PING and traceroute.
ip_address Specifies the IP address of the Telnet session to be
disconnected. This address is displayed in the output
shown in Section 11.2.2.9.
console Closes an active console port.
Matrix>disconnect 10.1.10.10
Matrix>disconnect console