IGMP Configuration Command Set
Configuring IGMP VLAN Registration
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 10-9
10.2.4 Configuring IGMP VLAN Registration
Purpose
Use these commands to configure IGMP VLAN Registration (IVR) on the device. IVR is designed
for applications using wide-scale deployment of multicast traffic. It eliminates the need to duplicate
multicast traffic for clients in each VLAN. Multicast traffic for all groups is only sent around the
VLAN trunk once — only on the multicast VLAN.
For more information about the use of IGMP VLAN Registration, refer to Section 10.3.1.
Command
The command used to configure IGMP VLAN registration are listed below and described in the
associated sections as shown.
•show igmp mode (Section 10.2.4.1)
•set igmp mode vlan (Section 10.2.4.2)
•set igmp mode ipaddress (Section 10.2.4.3)
•set igmp mode (Section 10.2.4.4)
10.2.4.1 show igmp mode
Use this command to display IVR information for one or more ports.
show igmp mode [port-string]
Syntax Description
Command Defaults
If port-string is not specified, IVR information will be displayed for all ports.
NOTE: IVR cannot be used when routing is enabled.
port-string (Optional) Displays IVR information for specific port(s).
For a detailed description of possible port-string values,
refer to Section 4.1.2.