Enterasys Networks 1G58x-09, 1H582-xx, E1 Series

IP Configuration Command Set

Reviewing IP Traffic and Configuring Routes

12-32 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide

Syntax Description

Command Type

Router command.

Command Mode

Privileged EXEC: Matrix>Router#

Command Defaults

If no parameters are specified, all IP route information will be displayed.

Example

This example shows how to display all IP route information. In this case, there are two IP routes

and each one is directly connected to a VLAN:

destination prefix

mask

longer-prefixes

(Optional) Converts the specified address and mask into a

prefix and displays any routes that match the prefix.

connected (Optional) Displays connected routes.

ospf (Optional) Displays routes configured for the OSPF routing

protocol.

rip (Optional) Displays routes configured for the RIP routing

protocol.

static (Optional) Displays static routes.

summary (Optional) Displays a summary of the IP routing table.

Matrix>Router#show ip route

Codes: C-connected, S-static, R-RIP, B-BGP, O-OSPF, IA-OSPF interarea

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - 0SPF external type 1, E2 - 0SPF external type 2

E - EGP, i - IS-IS, L1 - IS-IS level-1, LS - IS-IS level-2

* - candidate default, U - per-user static route, o - ODR

Gateway of last resort is not set

C 182.127.63.0/24 [0001] directly connected, Vlan 1

C 182.127.62.0/24 [0001] directly connected, Vlan 2