Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-107
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set flow limiting action 1 to discard all flows exceeding 12 on ports
classified as user ports:
discard | drop |
trap | disable Specifies the action to be taken if flow limit is reached as:
•Discarding excess flows. This causes a “discard flow” to
be created. Packets are accepted to this flow but are
discarded (not forwarded anywhere). This allows the
flow counters to be updated (and possibly reach a second
higher threshold action (for example: trap or disable, as
described below).
•Dropping excess flows. The E1 does not support this
option. If set, the E1 will behave the same as setting the
attribute to “discard” and discard flows will be created.
•Generating an SNMP trap notification (if the set
flowlimit notification function is enabled as described
in Section 14.3.9.7).
•Disabling the interface (if the set flowlimit shutdown
function is enabled as described in Section 14.3.9.6).
This will clear all FST settings on the port.
Matrix>set flowlimit limit 1 userport 12 discard