Security Configuration Command Set
Configuring Flow Setup Throttling (FST)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 14-105
14.3.9.2 set flowlimit Use this command to enable or disable flow setup throttling globally or on one or more port(s), or
to re-enable one or more port(s) that were disabled due to flow setup throttling.
set flowlimit {[system | port-string disable | enable] [port-string operational]}
Syntax Description
Command Type
Switch command.
Command Mode
Read-Write.
Flow limit
shutdown Whether flow limit shut down is enabled or disabled.
Default state of disabled can be changed with the set
flowlimit shutdown command (Section 14.3.9.6).
Flow limit
notification
interval
Interval in seconds at which an SNMP notification will be
sent when a specified flow limit is reached. This function
can be enabled, and the default interval of 120 can be
changed, with the set flowlimit notification command
(Section 14.3.9.7).
Flow limit
maximum
flowcount
Number of flows that, if exceeded, will trigger a configured
action. Set using the set flowlimit limit command
(Section 14.3.9.3).
Flow limit table Lists flow limits and assigned actions for FST port
classifications.
system |
port-string
disable | enable
Enables or disables FST globally or one specific port(s).
port-string
operational Re-enables one or more ports disabled by the flow limit
shut down function (as described in Section 14.3.9.6).
Table 14-8 show flowlimit Output Details (Continued)
Output What It Displays...