Process Overview: Routing Protocol Configuration
Configuring RIP
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-3
13.1.1.1 router rip
Use this command to enable or disable RIP configuration mode.
router rip
Configure RIP authentication. key chain (Section 13.1.1.9)
key (Section 13.1.1.10)
key-string (Section 13.1.1.11)
accept-lifetime (Section 13.1.1.12)
send-lifetime (Section 13.1.1.13)
ip rip authentication keychain (Section 13.1.1.14)
ip rip authentication mode (Section 13.1.1.15)
Disable automatic route summarization
(necessary for enabling CIDR) no auto-summary (Section 13.1.1.16)
Disable triggered updates. ip rip disable-triggered-updates (Section 13.1.1.17)
Disable or re-enable split horizon. ip split-horizon (Section 13.1.1.18)
Control the processing of routing updates. passive-interface (Section 13.1.1.19)
receive interface (Section 13.1.1.20)
distribute-list (Section 13.1.1.21)
Enable redistribution from non-RIP
routes. redistribute (Section 13.1.1.22)
NOTE: You must execute the router rip command to enable the protocol before
completing many RIP-specific configuration tasks. For details on enabling configuration
modes, refer to Tabl e 3 - 1 0 in Section 3.3.3.
Table 13-1 RIP Configuration Task List and Commands (Continued)
To do this... Use these commands...