Process Overview: Routing Protocol Configuration
Configuring OSPF
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 13-27
•Configure OSPF authentication. ip ospf authentication-key (Section 13.1.2.11)
ip ospf message digest key md5 (Section 13.1.2.12)
Configure OSPF Areas.
•Configure an administrative
distance. distance ospf (Section 13.1.2.13)
•Define the range of addresses to be
used by Area Boundary Routers
(ABRs).
area range (Section 13.1.2.14)
•Enable area authentication. area authentication (Section 13.1.2.15)
•Define an area as a stub area. area stub (Section 13.1.2.16)
•Set the cost value for the default
route that is sent into a stub area. area default cost (Section 13.1.2.17)
•Define an area as an NSSA. area nssa (Section 13.1.2.18)
Create virtual links. area virtual-link (Sectio n 13.1.2.19)
Enable passive OSPF mode on an
interface. passive-ospf (Section 13.1.2.20)
Enable redistribution from non-OSPF
routes. redistribute (Section 13.1.2.21)
Limit link state database overflow. database-overflow (Section 13.1.2.22)
Table 13-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...