General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-82 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to assign priority 7 to untrusted traffic from port ge.0.5:
3.2.6.14 set port ciscodp vvid
Use this command to set the voice VLAN ID for a Cisco DP port. This instructs the IP phone device
connected to this port how to tag voice traffic.
set port ciscodp vvid port-string {vlan-id | none | dot1p | untagged}
port-string Specifies the port(s) on which to set a CoS value. For a
detailed description of possible port-string values, refer to
Section 4.1.2.
classify-value Assigns a Class of Service to untrusted traffic. Valid values
are 0 - 7, with 0 given the lowest priority.
There is a one-to-one correlation between this classify-value
and the 802.1p value assigned to ingressed traffic by the
Cisco IP phone. A classify-value of 0 equates to an 802.1p
priority of 0, which is given lower priority than an 802.1p
priority of 7. Therefore, a classify-value of 7 is given the
highest priority.
undefined No CoS value is communicated to the Cisco IP phone.
Matrix>set port ciscodp cos-ext ge.0.5 7