Port Configuration Command Set
Setting Speed and Duplex Mode
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 4-13
4.3.2.2 set port enable
Use this command to administratively enable one or more ports.
set port enable port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Fast Ethernet front panel port 3:
4.3.3 Setting Speed and Duplex Mode
Purpose
To set the current operational speed in Mbps and to set the default duplex mode: Half, for half
duplex, or Full, for full duplex.
Commands
The commands needed to set port speed and duplex mode are listed below and described in the
associated section as shown.
•show port speed (Section 4.3.3.1)
port-string Specifies the port(s) to enable. For a detailed description
of possible port-string values, refer to Section 4.1.2.
Matrix>set port enable fe.0.3
NOTE: These settings only take effect on ports that have auto-negotiation disabled.