Spanning Tree Configuration Command Set
Reviewing and Setting Spanning Tree Port Parameters
6-40 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the blocked ports in SID 1:
6.2.2.5 show spantree portpri
Use this command to show the Spanning Tree priority for one or more ports. If the path cost for all
ports on a device is the same, the port with the highest priority (i.e., lowest value) will be configured
as an active link in the Spanning Tree. When more than one port is assigned the highest priority, the
port with the lowest numeric identifier will be enabled.
show spantree portpri port-string [sid]
Syntax Description
Command Defaults
If sid is not specified, port priority for SID 0 will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Matrix>show spantree blockedports 1
Port ge.0.1 in Blocking State.
Port ge.0.2 in Blocking State.
Port ge.0.3 in Blocking State.
Port ge.0.4 in Blocking State.
Port ge.0.5 in Blocking State.
Number of blocked ports in SID 1: 5
port-string Specifies the port(s) for which to display Spanning Tree
priority. For a detailed description of possible port-string
values, refer to Section 4.1.2.
sid (Optional) Displays priority for specific SID(s).