Process Overview: Routing Protocol Configuration
Configuring OSPF
13-58 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
13.1.2.27show ip ospf neighbor
Use this command to display the state of communication between an OSPF router and its neighbor
routers.
show ip ospf neighbor [detail] [ip_address] [vlan vlan_id]
Backup Designated
Router id IP address of the backup designated router on this interface,
if one exists.
Timer intervals
configured OSPF timer intervals. These are either default, or configured
with the ip ospf retransmit-interval (Section 13.1.2.7), the
ip ospf hello-interval (Section 13.1.2.9), and the ip ospf
dead interval (Section 13.1.2.10) commands. The wait
timer represents the amount of time a router waits before
initiating a designated router/backup designated router
election. The wait timer changes when the dead interval
changes. The retransmit timer represents the amount of time
between successive transmissions of LSAs (Link State
Advertisements) until acknowledgement is received.
Neighbor Count Number of neighbors over this interface.
Adjacent neighbor
count Number of adjacent (FULL state) neighbors over this
interface.
Adjacent with
neighbor IP address of the adjacent neighbor.
Table 13-4 show ip ospf interface Output Details (Continued)
Output What It Di splays...