Port Configuration Command Set
Configuring Unknown Destination Address Suppression
4-74 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Command Mode
Read-Only.
Example
This example shows how to display the status of unknown unicast traffic suppression on Fast
Ethernet front panel port 1. In this case, the default state of disabled has not been changed:
4.3.15.2 set port unknowndestsuppress Use this command to enable or disable the suppression of unknown unicast traffic transmission
from one or more ports.
set port unknowndestsuppress port-string [enable | disable]
Syntax Description
Command Defaults
If disable is not specified, suppression will be enabled.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable unknown destintation address suppression on Fast Ethernet
front panel port 1:
Matrix>show port unknowndestsuppress fe.0.1
Unknown Destination Forwarding Status
Port: Status:
====================
fe.0.1 Disabled
port-string Specifies port(s) on which to enable or disable
suppression. For a detailed description of possible
port-string values, refer to Section 4.1.2.
enable | disable (Optional) Enables or disables suppression.
Matrix>set port unknowndestsuppress fe.0.1