VLAN Configuration Command Set
Configuring the VLAN Egress List
7-18 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
7.3.4 Configuring the VLAN Egress List
Purpose
To assign or remove ports on the VLAN egress list for the device. This determines which ports will
transmit frames of a particular VLAN. For example, ports 1, 5, 9, 8 could be assigned to transmit
frames with VLAN ID=5.
The port egress type for all ports defaults to tagging transmitted frames, but can be changed to
forbidden or untagged. Setting a port to forbidden prevents it from participating in the specified
VLAN and ensures that any dynamic requests (either through GVRP or dynamic egress) for the port
to join the VLAN will be ignored. Setting a port to untagged allows it to transmit frames without a
tag header. This setting is usually used to configure a port connected to an end user device.
Commands
The commands used to configure VLAN egress and dynamic VLAN egress are listed below and
described in the associated section as shown.
•set vlan forbidden (Section 7.3.4.1)
•show port egress (Section 7.3.4.2)
•set vlan egress (Section 7.3.4.3)
•clear vlan egress (Section 7.3.4.4)
•show vlan dynamicegress (Section 7.3.4.5)
•set vlan dynamicegress (Section 7.3.4.6)
7.3.4.1 set vlan forbidden
Use this command to prevent one or more ports from participating in a VLAN. This setting instructs
the device to ignore dynamic requests (either through GVRP or dynamic egress) for the port to join
the VLAN.
set vlan forbidden vlan-id port-string