Logging and Network Management Command Set
Configuring System Logging
11-6 Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Table 11-1 provides an explanation of the command output.
Matrix>show logging all (Continued from previous page)
emergencies(1) alerts(2) critical(3)
errors(4) warnings(5) notifications(6)
information(7) debugging(8)
Minimum message level displayed on the console session: warnings(5)
Facility Severity Port
-------------------------------------------------------------
Defaults: local0 emergencies(1) 514
IP Address Facility Severity Port Status
-------------------------------------------------------------------------
1 10.1.129.55 local0 notifications(6) 514 active
1 Desc:Routing
Table 11-1 show logging all Output Details
Output What It Displays...
Global Logging
State Whether logging is globally enabled or disabled.
Application Mnemonic values for applications being logged. For details
on setting this value using the set logging application
command, refer to Section 11.2.1.12. For a list of valid values
and their corresponding applications, refer to Table 11-3.
Current Severity
Level Severity level (1 - 8) at which the server is logging messages
for the listed application. For details on setting this value
using the set logging application command, refer to
Section 11.2.1.12.
Defaults Default facility name, severity level and UDP port
designation (as described below.) For details on setting this
value using the set logging default command, refer to
Section 11.2.1.9.
IP Address Syslog server’s IP address. For details on setting this using
the set logging server command, refer to Section 11.2.1.6.