Changing Options for a Journal Group
To change options for a journal group, follow the procedure below. Both the primary storage system administrator and the secondary storage system administrator must perform this operation:
1.Ensure that the Storage Navigator main window is in Modify mode.
For detailed information about how to do this, please refer to Storage Navigator User’s Guide.
2.Ensure that the Journal Operation window is displayed (see section Changing Options for a Journal Group).
3.Do either of the following:
–In the tree,
–In the
Caution: You can select Change JNL Option only when one of the following conditions is satisfied:
–The attribute of the journal group is Initial.
–The status of the journal group is Active.
–The status of the journal group is Stop.
–The status of the journal group is Hold.
–The status of the journal group is Hold(Failure).
When one journal group uses multiple mirror IDs, whether you can or cannot select Change JNL Option depends on the status of the journal group whose mirror is not in Hold or Hold(Failure) status.
4.In the Change JNL Option window (Figure
Caution: If the status of the journal group is Active, or if the status of the master journal group is Hold, you can change only the Line of Speed option.
Note: If you have selected two or more journal groups in step 3, and want to make some options in the Change JNL Options window unchanged, then you must specify blank for the options. If you specify blank for an option, the option value will remain unchanged. If you specify a value other than blank, the specified value will be set to the selected journal groups.
5.See the Preview list in the Journal Operation window to check the settings that you have made.
–If you want to modify a setting, select and
–If you want to cancel a setting, select and
Chapter 6 Configuring Journal Groups |
