1.Ensure that the Storage Navigator main window is in Modify mode.
For detailed information about how to do this, please refer to Storage Navigator User’s Guide.
2.Ensure that the EXCTG Operation window is displayed.
3.In the EXCTG Operation window (Figure
4.Select Add JNLG to EXCTG from the
5.If you do not want to register journal groups of the supervisor DKC, clear the check box of far left of the DKCs
6.Select one from the DKCs
Notes:
–The word "DKC" represents a storage system.
–If you want to register journal groups of the supervisor DKC, please move on to step 11 after this step.
7.Enter the serial number of the storage system.
Note: If the serial number is already displayed and unchangeable, you do not need to enter it.
8.Enter the LDKC number.
Note: If the LDKC number is already displayed and unchangeable, you do not need to enter it.
9.Select the control ID.
10.Specify the LDKC number and the LDEV number of the remote command device.
Note: If the LDKC number and the LDEV number are already specified and unchangeable, you do not need to specify them.
11.From the JNLG list on the left, select one or more journal groups that you want to register.
12.Select
The selected journal groups move to the JNLG list on the right.
Note: If the JNLG list on the right contains any journal group that you do not want to register, please select the journal group from the list and then click
13.From Mirror ID, select a mirror ID.
Note: If a mirror ID is already specified and unchangeable, you do not need to select it.
14.If necessary, repeat steps 6 to 13.
15.Select Set to close the Add JNL Group window.
Chapter 7 Using Extended Consistency Groups |
