When the VIVID digitizer will be controlled from Polygon Editing Tool, connect the VIVID digitizer to the computer first, and then start up Polygon Editing Tool.
The first time the VIVID digitizer is connected to the computer, it is necessary for the computer to recognize the VIVID digitizer as an external device.
Perform operations according to the following procedure.
nConnecting the VIVID digitizer to the computer
In order for the protect key to be recognized by the corresponding driver software, it is necessary to install the driver software on the computer before connecting the protect key to the computer.
Operating Procedure
1 Turn the POWER switch of the computer OFF.
2 Connectputer. the VIVID digitizer to the com-
Memo
For details on how to connect the VIVID digitizer to the computer, refer to the instruction manual of each model of the VIVID digitizer.
Chapter 1
Preparations
3 Set the POWER switch of the VIVID digitizer to ON (set switch to “I” mark).
Initializing of the digitizer will start.
4 After MENU appears in the finder of the digitizer, switch on the computer to start the Windows operating system.
Note
The POWER switch of the digitizer should be set to ON first before switching on the computer.
0/7%2
!# ).3#3)
13